Insta360 X6 Power Selfie Stick

Power and control in one pole, so the camera keeps rolling long after it normally would. The built-in battery dramatically extends recording time, letting you shoot for hours rather than minutes. Run the camera without its own battery fitted and the centre of gravity shifts for a better balanced, more comfortable grip while still delivering long continuous recording. Power flows through the pin port on the bottom of the camera, so there are no cables to route and nothing to spoil the invisible selfie stick effect. On a motorcycle, connect the charging cable to the handlebar for uninterrupted recording without compromising stealth, keeping your ride safer and your footage running (a dual-head clamp is recommended).

A built-in button on the handle lets you control the camera directly once connected, with no pairing required. The quick-release mount makes fitting and removal fast, with a locking latch to stop accidental disconnection. The stick extends up to 1m for a wide range of angles, and a 1/4" threaded mount on the base attaches to tripods, motorcycle clamps and other accessories.

Recommended For

Extended Shooting Sessions: The built-in battery charges the X6 while you shoot, delivering up to roughly 6 hours of continuous recording on a single stick.

Motorcycling: The high-strength shaft supports on-road motorcycle use, and connecting the charging cable to the handlebar keeps recording uninterrupted without spoiling the stealth of the setup.

Quick-release Workflows: The quick-release mount with locking latch makes fitting and removing the camera fast between shots, with no accidental disconnection.

Tripod & Clamp Setups: The bottom 1/4" threaded shaft attaches to tripods, motorcycle clamps and other accessories for more mounted shooting scenarios.

Invisible 360 Shots: Power flows through the camera's pin port with no cables to route, so nothing spoils the invisible selfie stick effect.

Key Features:

Greatly Extends Continuous Recording Time

Cable-Free Charging Via Pin Port

Built-In Button, No Pairing Needed

Quick-Release Mount with Locking Latch

Extends To 1m, 1/4" Thread